Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T02:30:25.669Z Has data issue: false hasContentIssue false

Surface Sensitive Spectroscopy Study of Ion Beam Irradiation Induced Structural Modifications in Borosilicate Glasses

Published online by Cambridge University Press:  18 March 2013

Amy S. Gandy
Affiliation:
Immobilisation Science Laboratory, Department of Materials Science and Engineering, The University of Sheffield, Mappin Street, Sheffield S1 3JD, UK
Martin C. Stennett
Affiliation:
Immobilisation Science Laboratory, Department of Materials Science and Engineering, The University of Sheffield, Mappin Street, Sheffield S1 3JD, UK
Neil C. Hyatt
Affiliation:
Immobilisation Science Laboratory, Department of Materials Science and Engineering, The University of Sheffield, Mappin Street, Sheffield S1 3JD, UK
Get access

Abstract

Fe K edge X-ray absorption (XAS) and Fourier Transform Infra-Red (FT-IR) spectroscopies have been used to study potential structural modifications in sodium borosilicate glasses as a consequence of Kr+ irradiation. Glasses were doped with simulant waste elements and irradiated at room temperature with 450 keV Kr+ ions to a fluence of 2x1015 Kr+ ions cm-1. According to SRIM calculations, a damaged surface region approximately 400nm wide was produced. In order to probe only the damaged surface layer, XAS measurements were taken in total electron yield mode and FT-IR spectroscopy was conducted in reflectance off the glass surface. No change in Fe valence state was detected by XAS following irradiation. Reflectance FT-IR data revealed a shift to higher wavenumbers in the absorption bands located between 850 and 1100 cm-1 in the doped glasses, corresponding to bond stretching in the silicate network. Deconvolution of FT-IR spectra revealed the shift was due to polymerisation of the silicate network. Network connectivity was found to decrease in the un-doped glass, following irradiation. The results suggest an increase in silicate network connectivity by a cation mediated process, and demonstrates the successful application of surface sensitive XAS and FT-IR to the investigation of ion beam induced damage in amorphous materials.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable