Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T18:44:42.292Z Has data issue: false hasContentIssue false

Testing of Critical Features of Polysilicon MEMS

Published online by Cambridge University Press:  10 February 2011

D. A. Lavan
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185, dalavan@sandia.gov
T. E. Buchheit
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185, dalavan@sandia.gov
Get access

Abstract

The behavior of MEMS devices is limited by the strength of critical features such as thin ligaments, oxide cuts joining layers, pin joints and hinges. Devices fabricated at Sandia's Microelectronic Development Laboratory have been successfully tested to investigate these features. A series of measurements were performed on samples with gage lengths of 15 to 1000 microns, using conventional and tungsten coated samples as well as samples that include the critical features of standard components in the test section. Specimens have a freely moving pin joint on one end that anchors the sample to the silicon die to allow rotation to reduce effects of bending. Each sample is loaded in uniaxial tension by pulling laterally with a flat tipped diamond in a computer-controlled Nanoindenter. Load is calculated by resolving the measured lateral and normal forces into the applied tensile force and frictional losses. The specimen cross section and gage length dimensions were verified by measuring against a standard in the SEM. Multiple tests can be programmed at one time and performed without operator assistance allowing the collection of significant populations of data.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable