Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T16:13:46.759Z Has data issue: false hasContentIssue false

Texture Studies of Gamma Titanium Aluminide Sheets Produced by Melt Overflow Rapid Solidification

Published online by Cambridge University Press:  15 February 2011

M. L. Weaver
Affiliation:
Center for Nonlinear & Nonequilibrium Aeroscience, Florida A&M University, Tallahassee, FL 32306–4005
H. Garmestani
Affiliation:
Department of Mechanical Engineering, FAMU-FSU College of Engineering, Tallahassee, FL 32310–2175
G. Das
Affiliation:
Pratt & Whitney Aircraft, West Palm Beach, FL 33410–9600
Get access

Abstract

Texture analyses have been conducted on gamma titanium aluminide (γ-TiAI) strips produced using the recently developed plasma melt overflow process. The results indicated that <101] deformation textures persisted in the γ-phase while <0002>, <1010> and <1020> texture components were all observed in the α2-phase. After annealing at 1065°C/48 hrs., the γ-phase textures did not change while the α2-phase changed from a basal to a <1010> texture. It is suggested that the texture development in direct cast γ strips produced using this technique are a direct result of lattice rotations and residual stresses caused by nonuniform cooling.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable