Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T02:03:28.258Z Has data issue: false hasContentIssue false

Thermal Stresses in Passivated Copper Interconnects Determined by X-Ray Analysis and Finite Element Modeling

Published online by Cambridge University Press:  22 February 2011

R.P. Vinci
Affiliation:
Department of Materials Science, Stanford University, Stanford, CA 94305-2205
E.M. Zielinski
Affiliation:
Department of Materials Science, Stanford University, Stanford, CA 94305-2205
J.C. Bravman
Affiliation:
Department of Materials Science, Stanford University, Stanford, CA 94305-2205
Get access

Abstract

Stresses in passivated copper lines were determined from strains measured using x-ray methods and compared to stresses calculated using finite element methods. Copper lines, 2 µm wide by 0.8 µm thick, were fabricated by DC magnetron sputtering and lift off patterning. The cross section of these lines was trapezoidal, with approximately 50° sidewalls. One set of samples was left bare, the others passivated with Si3N4 in several different thicknesses. Strain was determined using x-rays. Stress was calculated using elastic moduli adjusted for predominantly (111) fiber texture. Elastic-plastic finite element models provided comparisons of the effects of passivation thickness, rectangular and trapezoidal cross section, and mechanical anisotropy due to preferred texture on the hydrostatic stress in a line. A similar model for aluminum also provided a comparison case of stress as a function of passivation thickness.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable