Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-16T11:35:38.891Z Has data issue: false hasContentIssue false

Thin Film Polycrystalline Si by Cs Solution Growth Technique

Published online by Cambridge University Press:  28 February 2011

Richard L. Wallace
Affiliation:
State University of New York at Buffalo, Department of Electrical and Computer Engineering, Buffalo, NY 14260
Wayne A. Anderson
Affiliation:
State University of New York at Buffalo, Department of Electrical and Computer Engineering, Buffalo, NY 14260
K. M. Jones
Affiliation:
National Renewable Energy Laboratory, 1617 Cole Blvd., Golden CO 80401-3393
Get access

Abstract

A deposition process has been developed which allows the growth of large grain (20+ μm) polysilicon films on SiO2 substrates at a growth temperature of 650° C. A thin layer of liquid Si-metal solution is formed on the substrate surface as the growth medium. This layer is kept saturated by Si flux from a DC magnetron sputter gun. XRD analysis of the deposited films show a strong (111) preferred orientation, with increasing integrated peak intensities with increasing depositon temperature and solution layer thickness. Films deposited using an In-Si solution are p-type, with carrier concentrations in the mid 1016 cm−3 range. Conductivities of ∼.2 (Ω cm)−1 were measured, with activation energies for both carrier generation and conductivity of about 135meV. The hole mobility was found to be ∼ 30 cm2 V−1s−1. A wetting layer is used which may have a detrimental effect on the minority carrier lifetime.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable