Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T06:24:31.697Z Has data issue: false hasContentIssue false

Thin-film Photodiode with an a-Si:H/nc-Si:H Absorption Bilayer

Published online by Cambridge University Press:  28 June 2011

Y. Vygranenko*
Affiliation:
Electronics, Telecommunications and Computer Engineering, ISEL, 1949-014 Lisbon, PortugalCTS-UNINOVA, 2829-516 Caparica, Portugal
M. Vieira
Affiliation:
Electronics, Telecommunications and Computer Engineering, ISEL, 1949-014 Lisbon, PortugalCTS-UNINOVA, 2829-516 Caparica, Portugal
A. Sazonov
Affiliation:
Electrical and Computer Engineering, University of Waterloo, Waterloo, N2L 3G1, Canada
*
*Corresponding author: yvygranenko@deetc.isel.ipl.pt
Get access

Abstract

We report on the fabrication and characterization of n+-n-i-δi-p thin-film photodiodes with an active region comprising a hydrogenated nanocrystalline silicon (nc-Si:H) n-layer and a hydrogenated amorphous silicon (a-Si:H) i-layer. The combination of wide- and narrow-gap absorption layers enables the spectral response extending from the near-ultraviolet (NUV) to the near-infrared (NIR) region. Moreover, in the low-bias range, when only the i-layer is depleted, the leakage current is significantly lower than that in the conventional nc-Si:H n+-n-p+ photodiode deposited under the same deposition conditions. Device with the 900nm/400nm thick n-i-layers exhibits a reverse dark current density of 3 nA/cm2 at −1V. In the high-bias range, when the depletion region expands within the n-layer, the magnitude of the leakage current depends on electronic properties of nc-Si:H. The density of shallow and deep states, and diffusion length of holes in the n-layer have been estimated from the capacitance-voltage characteristics and from the bias dependence of the long-wavelength response, respectively. To improve the quantum efficiency in the NIR-region, we have also implemented a Cr / ZnO:Al back reflector. The observed long-wavelength spectral response is about twice as high as that for a reference photodiode without ZnO:Al layer. Results demonstrate the feasibility of the photodiode for low-level light detection in the NUV-to-NIR spectral range.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable