Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-18T04:21:39.813Z Has data issue: false hasContentIssue false

Transient Annealing of Boron Implanted Devices

Published online by Cambridge University Press:  22 February 2011

S. R. Wilson
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
W. M. Paulson
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
C. J. Varker
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
A. Lowe
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
R. B. Gregory
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
R. H. Reuss
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
S. Y. Wu
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
J. D. Whitfield
Affiliation:
Semiconductor Research and Development Laboratory, Motorola, Inc. 5005 E. McDowell Road, Phoenix, AZ 85008
Get access

Abstract

Shallow-junction semiconductor devices have been fabricated using ion implantation and transient annealing with a Varian IA-200 isothermal annealer. Boron implanted diodes, npn bipolar transistors and CMOS ring oscillators have been fabricated and are compared to furnace annealed devices. Boron implanted diodes have been annealed with the RIA and yield acceptably low leakage currents, comparable to furnace annealed devices. The RIA devices have recombination lifetimes of ∼10 μsec. The bipolar transistors subjected to a transient anneal have good base-collector and emitterbase junctions as well as gains of ∼100 in good agreement with the design of the device. MOSFETs and CMOS ring oscillators were fabricated using self-aligned polysilicon gates. The transient annealed devices were equal or superior to devices which were furnace annealed at 800°C for 10 min. The low temperature furnace anneal was necessary to minimize short channel effects. The transient anneal resulted in ring oscillators which were a factor of two faster than furnace samples that were annealed.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1984

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable