Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T02:58:12.041Z Has data issue: false hasContentIssue false

Understanding and Modeling Ramp Rate Effects on Shallow Junction Formation

Published online by Cambridge University Press:  17 March 2011

Srinvasan Chakravarthi
Affiliation:
Department of Manufacturing Engineering, Bosten University, Bosten, MA 02215
Alp H. Gencer
Affiliation:
Avant! Corp., TCAD Division, Wellesle, MA
Scott T. Dunham
Affiliation:
Department of Electrical Engineering, University of Washington, Seattle, WA, 98195
Daniel F. Downey
Affiliation:
Varian Semiconductor Equipment Associates, Gloucester, WA 01930
Get access

Summary

In summary, we find it is possible to model the extent of diffusion during spike anneals with varying ramp rates by considering the full thermal cycle. These models allow the optimization of RTP ammealing cycles considering the trade-offs between junction depth and sheet resistance. For example, with 1050°C spike anneals, the active dose (and thus sheet conductivity) varies approximately linearly with junction depth. However, faster ramp rates allow the use of higher spike temperatures, with associated higher activation and reduced sheet resistance for the same junction depth.

Work at Bosten University and the University of Washington was supported by the Semiconductor Research Corporation. We would like to thank Eric Perozziello for details and discussion regarding their experimental results.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable