Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T09:08:30.410Z Has data issue: false hasContentIssue false

Adhesive Failure of a Thin Epoxy Film on an Aluminized Substrate

Published online by Cambridge University Press:  17 March 2011

N. R. Moody
Affiliation:
Sandia National Laboratories, Livermore CA 94550
D. F. Bahr
Affiliation:
Washington State University, Pullman, WA 99164
M. S. Kent
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185
J. A. Emerson
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185
E. D. Reedy Jr.
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185
Get access

Abstract

In this study we used nanoindentation to determine mechanical properties and combined nanoindentation with stressed overlayers to determine interfacial fracture energy of a 164 nm thick film of Epon 828/T403 on an aluminized glass substrate. The combination of nanoindentation and a tungsten overlayer was required to trigger delamination of the epoxy film from the aluminized substrate. Mechanics-based models for circular blister formation were then used to determine residual stresses and interfacial fracture energies. This approach showed that the tungsten overlayer had a compressive residual stress of 1.9 GPa which drove blister formation at a fracture energy of 1.9 J/m2 with a phase angle of loading equal to –62°.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable