Hostname: page-component-7b7567c8c-tnzcf Total loading time: 0 Render date: 2026-11-12T16:23:38.906Z Has data issue: false hasContentIssue false

All Solid-State Batteries Using Super Ionic Conductor, Thio-Lisicon – Electrode/Electrolyte interfacial Design

Published online by Cambridge University Press:  01 February 2011

Takesh Kobayashi
Affiliation:
Department of Electronic Chemistry, Interdisciplinary Graduate School of Science and Engineering, Tokyo Institute of Technology, Nagatsuta, Midori, Yokohama, 226–8502, Japan
Taro Inada
Affiliation:
Department of Electronic Chemistry, Interdisciplinary Graduate School of Science and Engineering, Tokyo Institute of Technology, Nagatsuta, Midori, Yokohama, 226–8502, JapanResearch Center, Denki Kagaku Kogyo K. K., Asahi-machi, Machida, Tokyo, 194–8560, Japan
Noriyuki Sonoyama
Affiliation:
Department of Electronic Chemistry, Interdisciplinary Graduate School of Science and Engineering, Tokyo Institute of Technology, Nagatsuta, Midori, Yokohama, 226–8502, Japan
Atsuo Yamada
Affiliation:
Department of Electronic Chemistry, Interdisciplinary Graduate School of Science and Engineering, Tokyo Institute of Technology, Nagatsuta, Midori, Yokohama, 226–8502, Japan
Ryoji Kanno*
Affiliation:
Department of Electronic Chemistry, Interdisciplinary Graduate School of Science and Engineering, Tokyo Institute of Technology, Nagatsuta, Midori, Yokohama, 226–8502, Japan
*
* E-mail address: kanno@echem.titech.ac.jp
Get access

Abstract

All solid-state ceramic lithium battery was studied using a composite anode, the thio-LISICON (Li3.25Ge0.25P0.75S4) solid electrolyte, and the Chevrel phase cathode. The nano-composite of cathode configuration reduced the interfacial resistance and provided fast-charge transfer at the interface. The self-assembled solid-electrolyte interfacial (SEI) phase was formed at the Li-Al/SE interface, while no formation was observed at the Li-In/SE interface. The SEI phase reduced the interfacial resistance and provided high charge-discharge characteristics. The all solid-state cell showed high current density of 1.3C rate and is a promising candidate for future lithium battery system.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable