Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T23:06:29.333Z Has data issue: false hasContentIssue false

Amorphous Ti-Si-N Barrier Metal for Cu Metallization on Ulsis

Published online by Cambridge University Press:  21 February 2011

Tadashi Iijima
Affiliation:
ULSI Research Labs. R&D Center, Toshiba Corporation, 1 Komukai Toshiba-cho, Saiwai-ku, Kawasaki 210, Japan
Yoshiaki Shimooka
Affiliation:
ULSI Research Labs. R&D Center, Toshiba Corporation, 1 Komukai Toshiba-cho, Saiwai-ku, Kawasaki 210, Japan
Kyoichi Suguro
Affiliation:
ULSI Research Labs. R&D Center, Toshiba Corporation, 1 Komukai Toshiba-cho, Saiwai-ku, Kawasaki 210, Japan
Get access

Abstract

We have investigated the physical properties of Ti-Si-N films for future Cu metallization on ULSIs. Our Ti-Si-N films were found to be amorphous by X-ray diffraction measurements. Thermal stability of the amorphous structure was confirmed, even after annealing at 600°C for 30 minutes in an Ar ambient. The atomic composition of the film was identified as Ti:Si:N=1:0.6:1.6 by chemical analysis. The film stress was found to be tensile and 0.3GPa. The electrical resistivity was about 0.5m Ωcm at room temperature.

The effectiveness of the film as a diffusion barrier was evaluated by n+/p and p+/n junction leakage measurements. The junction depth was 0.2Ω m and the contact area was 300×80μ2. No degradation of leakage characteristics was observed for these diodes, even after annealing at 600°C for 30 minutes in an N2/H2 ambient.

These results demonstrate that amorphous Ti-Si-N barrier metal is a promising candidate for application in deep-submicron ULSIs.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable