Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-18T00:34:59.212Z Has data issue: false hasContentIssue false

Anode Hosts for Lithium Batteries: Revisiting Tin and Aluminum

Published online by Cambridge University Press:  01 February 2011

Quan Fan
Affiliation:
Department of Chemistry, State University of New York at Binghamton Binghamton, New York 13902
Peter Zavalij
Affiliation:
Department of Chemistry, State University of New York at Binghamton Binghamton, New York 13902
M. Stanley Whittingham*
Affiliation:
Department of Chemistry, State University of New York at Binghamton Binghamton, New York 13902
Get access

Abstract

Pure tin reacts readily with four lithium atoms, and so is a prime candidate as the host for the anode of lithium batteries. Tin foil and an expanded tin grid (microporous tin) have a capacity of >600 mAh/g over more than 10 deep reaction cycles, indicating the inherent reversibility of tin anode. The microporous tin showed superior chemical capacity retention. Different phases are observed during the intercalation of lithium. Capacity loss was observed after 10 cycles though, consistent with the significant increase of the cell impedance. For comparison aluminum expanded grids were also examined as hosts, where LiAl is formed. Capacities approaching 1 Ah/g were obtained. LiBOB (lithium bis(oxalato)borate) was also studied as the electrolyte salt for comparison with the reactive and high cost LiPF6 salt.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable