Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T23:02:46.219Z Has data issue: false hasContentIssue false

Biomimetic Processing of Ceramics and Ceramic-Metal Composites

Published online by Cambridge University Press:  28 February 2011

M. Yasrebi
Affiliation:
Department of Materials Science and Engineering; and Advanced Materials Technology Center, Washington Technology Centers, University of Washington, Seattle, Washington 98195 USA
G. H. Kim
Affiliation:
Department of Materials Science and Engineering; and Advanced Materials Technology Center, Washington Technology Centers, University of Washington, Seattle, Washington 98195 USA
K. E. Gunnison
Affiliation:
Department of Materials Science and Engineering; and Advanced Materials Technology Center, Washington Technology Centers, University of Washington, Seattle, Washington 98195 USA
D. L. Milius
Affiliation:
Department of Materials Science and Engineering; and Advanced Materials Technology Center, Washington Technology Centers, University of Washington, Seattle, Washington 98195 USA
M. Sarikaya
Affiliation:
Department of Materials Science and Engineering; and Advanced Materials Technology Center, Washington Technology Centers, University of Washington, Seattle, Washington 98195 USA
I. A. Aksay
Affiliation:
Department of Materials Science and Engineering; and Advanced Materials Technology Center, Washington Technology Centers, University of Washington, Seattle, Washington 98195 USA
Get access

Abstract

Biomimetic design and processing of laminated B4C-Al cermets, based on knowledge gained from the microstructure-property characterization of abalone shells, is described. In the nacre section of the shell, the microstructure is highly organized as CaCO3 (aragonite) crystals, with a thickness of 0.25 μm, separated by a layer of organic matter 300–500 Å thick. This organization forms a miniature “brick and mortar” microstructure. The resultant strength and fracture toughness of the nacre, i.e., 180 MPa and 7 MPa-m1/2 , are many orders of magnitude higher than those of monolithic CaCO3. The processing of laminated B4C-Al cermets, based on the microstructure of the nacre, was performed by a combination of tape casting of the ceramic and infiltration of the metal. The resultant cermets displayed a 40% increase in both fracture toughness and strength over monolithic B4C-Al cermets.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable