Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T11:00:53.588Z Has data issue: false hasContentIssue false

Built-In Strain in Polysilicon: Measurement and Application to Sensor Fabrication

Published online by Cambridge University Press:  10 February 2011

H. Guckel*
Affiliation:
ECE Department, University of Wisconsin - Madison, Madison, WI 53706, guckel@engr.wisc.edu
Get access

Abstract

The built-in strain in deposited polysilicon films depends on film morphology. The strain may be compressive or tensile. Its magnitude and uniformity may be measured by using surface micro machining with test structures which require a single photomask level and use Euler buckling. Anneal cycles may be used to convert compressive strain to tensile or zero strain. Deposition and anneal cycles may be optimized to produce fine grained polysilicon with isotropic mechanical behavior.

Strain field control can improve yield by reducing surface sticking. This mechanical stiffening is used in, for instance, pressure transducer construction. Built-in and applied axial strain are used to change the resonant frequencies of clamped-clamped beams in a vacuum envelope where quality factors up to 300,000 have been measured.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable