Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T21:03:42.551Z Has data issue: false hasContentIssue false

Bulk and Defect Properties of Ordered Intermetallics: A First-Principles Total-Energy Investigation

Published online by Cambridge University Press:  01 January 1992

C. L. Fu
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, P.O. Box 2008, Oak Ridge, TN 37831
Y.-Y. Ye*
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, P.O. Box 2008, Oak Ridge, TN 37831
M. H. Yoo
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, P.O. Box 2008, Oak Ridge, TN 37831
*
* Permanent address: Dept. of Physics, Wuhan University, Hubei, Wuhan, PRC; currently at Dept. of Materials Science and Engineering, University of Tennessee, Knoxville,
Get access

Abstract

First-principles quantum mechanical calculations based on local-density-functional theory have been used to investigate the fundamental factors that govern the deformation and fracture behavior of ordered intermetallic alloys. Unlike in Ni3Al, the calculated elastic constants and shear fault energies indicate that anomalous yield strength behavior is not likely to occur in Ni3Si. From the calculated Griffith strength and a phenomenological theory relating fracture toughness to ideal cleavage strength, Ni3Si is predicted to be ductile with respect to cleavage fracture. For TiAl, we find the absence of structural vacancies due to the strong Ti-Al bonding and similar atomic radii for Ti and Al. For NiAl, the defect structure is found to be dominated by two types of defects - monovacancies on the Ni sites and substitutional antisite defects on the Al sites. For FeAl, on the other hand, we find a more complex defect structure, which is closely related to the importance of electronic structure effect in FeAl. More importantly, we predict the strong tendency for vacancy clustering in FeAl due to the large binding energy found for divacancies. Effects of thermomechanical history on microhardness are discussed in terms of the calculated results.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable