Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T02:06:55.946Z Has data issue: false hasContentIssue false

Bulk Synthesis of Completely and Partially Sn filled CoSb3 Using the Multilayer Repeat Method

Published online by Cambridge University Press:  01 February 2011

Heike Sellinschegg
Affiliation:
University of Oregon, Dept. of Chemistry and Materials Science Institute, Eugene, OR 97403
David C. Johnson
Affiliation:
University of Oregon, Dept. of Chemistry and Materials Science Institute, Eugene, OR 97403
Michael Kaeser
Affiliation:
Clemson University, Department of Physics, Clemson, SC 29634
Terry M. Tritt
Affiliation:
Clemson University, Department of Physics, Clemson, SC 29634
George S. Nolas
Affiliation:
R & D Division, Marlow Industries, Dallas, TX 75238
E. Nelson
Affiliation:
U.S. Army Research Laboratory, Adelphi, ML 20783
Get access

Abstract

Filled skutterudite compounds possess very low thermal conductivities due to the scattering of a wide range of phonon modes caused by a loosely bound cation incorporated in a cavity of the structure. The inclusion of such a filler cation causes several synthetic difficulties since the desired compounds are thermodynamically unstable with respect to disproportionation. Modulated elemental reactants were used in this study to circumvent these difficulties. SnxCo4Sb12 samples with x=0.5 and nearly 1.0 were synthesized using this method. To prevent nucleation of unwanted binary compounds, the repeat unit made up of elemental layers was less than 20 angstroms 500mg of each sample were produced, allowing for the samples to be hot pressed into a pellet. Structural analysis as well as measurements of the physical properties are presented.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable