Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T07:11:13.094Z Has data issue: false hasContentIssue false

Characterization of Highly Waste Loaded Glass for HLW

Published online by Cambridge University Press:  15 February 2011

Kazuhiro Kawamura
Affiliation:
Power Reactor and Nuclear Fuel Development Corporation (PNC), Tokai-works, 4–33 Muramatsu, Tokai-mura, Naka-gun, Ibaraki-ken, 319–11, JAPAN
Jin Ohuchi
Affiliation:
Power Reactor and Nuclear Fuel Development Corporation (PNC), Tokai-works, 4–33 Muramatsu, Tokai-mura, Naka-gun, Ibaraki-ken, 319–11, JAPAN
Get access

Abstract

Possibility of highly waste loaded borosilicate glasses up to 65wt% were investigated for HLW. In the case the waste was loaded at a content higher than 45wt%, apatite crystal was identified in the glasses. Adding above 2.5wt% of M0O3, yellow phase was observed in the 45wt% waste glass. In the case the composition of actual waste was simulated, waste(25–45wt%) glasses were characterized. Chemical durability of 45wt% waste glass was equivalent to that of 25wt% waste glass under the condition of Na20 content lower than 12wt%. Rheological behavior of 45wt% waste glass was equivalent to that of 25wt% waste glass in the range of melting temperature. Electrical resistivity of 45wt% waste glass were a little lower than that of 25wt% waste glass and it depended on the noble metal content. The Time-Temperature-Transformation (T-T-T) diagram and the leach rate of heat treated glass indicated a good thermal stability of highly waste loaded glass below the glass transition temperature. Possibility of high waste loading up to 45wt% was elucidated.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable