Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T04:21:45.541Z Has data issue: false hasContentIssue false

Characterization of Low Temperature, Wafer-Level Gold-Gold Thermocompression Bonds

Published online by Cambridge University Press:  10 February 2011

Christine H. Tsau
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
Martin A. Schmidt
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
S. Mark Spearing
Affiliation:
Massachusetts Institute of Technology, Cambridge, MA
Get access

Abstract

Low temperature, wafer-level bonding offers several advantages in MEMS packaging, such as device protection during aggressive processing/handling and the possibility of vacuum sealing. Although thermocompression bonding can be achieved with a variety of metals, gold is often preferred because of its acceptance in die bonding [1] and its resistance to oxidation. This study demonstrates that the simultaneous application of moderate pressure (0.5 MPa) and temperature (300°C) produces strong wafer-level bonds. A four-point benddelamination technique was utilized to quantify bond toughness. Test specimens exhibited constant load versus displacement behavior during steady state crack propagation. Two distinct fracture modes were observed: cohesive failure within the Au and adhesive failure at the Ti-Si interface. The strain energy release rate for Au-Au fracture was found to be higher than that associated with Ti-Si fracture, consistent with the greater plastic deformation that occurs in the metal during fracture.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable