Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T22:44:44.237Z Has data issue: false hasContentIssue false

Characterization of Plasma-Deposited Amorphous Carbon Films*

Published online by Cambridge University Press:  25 February 2011

Wen. L. Hsu
Affiliation:
Sandia National Laboratories, Livermore, CA 94550
G. W. Foltz
Affiliation:
Sandia National Laboratories, Livermore, CA 94550
F. A. Greulich
Affiliation:
Sandia National Laboratories, Livermore, CA 94550
K. F. Mccarty
Affiliation:
Sandia National Laboratories, Livermore, CA 94550
G. J. Thomas
Affiliation:
Sandia National Laboratories, Livermore, CA 94550
P. F. Green
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185
B. L. Doyle
Affiliation:
Sandia National Laboratories, Albuquerque, NM 87185
Get access

Abstract

Thin carbon films of ˜ 600 Å have been deposited on Si <111> wafers by striking an RF discharge in gas mixtures of hydrogen and methane. The deposition rate increased with increasing methane fraction. The peak rate was ˜ 1 Å/sec at an applied power density of 0.4 W cm−2. The films, with an average density of 2.54 gm cm−3, are amorphous in nature but exhibit broad diffraction maxima corresponding to interatcidc spacings of 2.05Å and 1. 15Å. Measurements of hydrogen concentration in the films showed that the hydrogen at. % [H/(H+C)] increased from 30 to 40% as the hydrogen fraction in the feed gas increased. By using a D2-CH4, we were also able to deduce that hydrogen molecules can be a large source of hydrogen trapped in the films.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable