Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T16:15:36.751Z Has data issue: false hasContentIssue false

Chemically Modified Second Harmonic Generation at Surfaces on Vicinal Si(111) Wafers

Published online by Cambridge University Press:  25 February 2011

U. Emmerichs
Affiliation:
Institute of Semiconductor Electronics II, Rheinisch-Westfälische Technische Hochschule, 5100 Aachen, Germany
C. Meyer
Affiliation:
Institute of Semiconductor Electronics II, Rheinisch-Westfälische Technische Hochschule, 5100 Aachen, Germany
K. Leo
Affiliation:
Institute of Semiconductor Electronics II, Rheinisch-Westfälische Technische Hochschule, 5100 Aachen, Germany
H. Kurz
Affiliation:
Institute of Semiconductor Electronics II, Rheinisch-Westfälische Technische Hochschule, 5100 Aachen, Germany
C. H. Bjorkman
Affiliation:
Departments of Physics, and Material Science and Engineering, North Carolina State University, Raleigh, NC 27695–8202, USA
C. E. Shearon Jr
Affiliation:
Departments of Physics, and Material Science and Engineering, North Carolina State University, Raleigh, NC 27695–8202, USA
Y. Ma
Affiliation:
Departments of Physics, and Material Science and Engineering, North Carolina State University, Raleigh, NC 27695–8202, USA
T. Yasuda
Affiliation:
Departments of Physics, and Material Science and Engineering, North Carolina State University, Raleigh, NC 27695–8202, USA
G. Lucovsky
Affiliation:
Departments of Physics, and Material Science and Engineering, North Carolina State University, Raleigh, NC 27695–8202, USA
Get access

Abstract

Using surface second harmonic generation (SSHG) at 1053nm, we study the influence of off-axis orientation and surface structure of silicon (111) surfaces. We study wafers cut at angles between 0° and 5° in the [112] direction. The surface structure is varied by thermal oxidation at 850°C, annealing, and thinning the oxide in a HF solution. For comparison, nitride films are also investigated. The characteristic rotational symmetry of the SSHG-signal for (111) flat (non-vicinal) surfaces is enhanced by a Si/SiO2 interface. The oxide layer also influences the signals due to the steps on vicinal surfaces. The results are discussed in comparison with a microscopic model of the oxidized misoriented surface.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable