Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-17T05:59:46.292Z Has data issue: false hasContentIssue false

Cu2ZnSnS4 thin film solar cell fabricated by magnetron sputtering and sulfurization

Published online by Cambridge University Press:  28 February 2014

Jian Chen
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Chang Yan
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Wei Li
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Ning Song
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Fangyang Liu
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Shujuan Huang
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Xiaojing Hao
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Martin A. Green
Affiliation:
School of Photovoltaics and Renewable Energy, University of New South Wales, NSW 2052, Australia.
Get access

Abstract

In this work, sulfurizing metal precursors prepared by magnetron sputtering was applied in Cu2ZnSnS4 (CZTS) thin film fabrication. Three precursor structures, namely substrate/ Zn/(Cu&Sn), substrate/Zn/Cu/Sn/Cu and substrate/Zn/Sn/Cu, were compared for their synthesized CZTS film quality. It is notable that CZTS film made of the precursor structure of substrate/Zn/(Cu&Sn) has the best film quality with no obvious voids and biggest average grain size. When applying this precursor structure into device fabrication, a working CZTS device with an efficiency of 2.26% was made. The impact of metal precursors on the structural property of CZTS film were characterised by SEM, XRD, Raman and TEM. Thick MoS2 interfacial layer (∼200nm) between absorber and back Mo contact and ZnS formed in the front and back absorber regions are the possible reasons limiting short-circuit current and fill factor of the cell.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2014 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable