Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T20:52:59.734Z Has data issue: false hasContentIssue false

Defect Microstructures and Deformation Mechanisms in Irradiated Austenitic Stainless Steels

Published online by Cambridge University Press:  15 February 2011

S. M. Bruemmer
Affiliation:
Pacific Northwest National Laboratory, Richland, Washington
J. I. Cole
Affiliation:
Pacific Northwest National Laboratory, Richland, Washington
R. D. Carter
Affiliation:
University of Michigan, Ann Arbor, Michigan
G. S. Was
Affiliation:
University of Michigan, Ann Arbor, Michigan
Get access

Abstract

Microstructural evolution and deformation behavior of austenitic stainless steels are evaluated for neutron, heavy-ion and proton irradiated materials. Radiation hardening in austenitic stainless steels is shown to result from the evolution of small interstitial dislocation loops during lightwater-reactor (LWR) irradiation. Available data on stainless steels irradiated under LWR conditions have been analyzed and microstructural characteristics assessed for the critical fluence range (0.5 to 10 dpa) where irradiation-assisted stress corrosion cracking susceptibility is observed. Heavy-ion and proton irradiations are used to produce similar defect microstructures enabling the investigation of hardening and deformation mechanisms. Scanning electron, atomic force and transmission electron microscopies are employed to examine tensile test strain rate and temperature effects on deformation characteristics. Dislocation loop microstructures are found to promote inhomogeneous planar deformation within the matrix and regularly spaced steps at the surface during plastic deformation. Twinning is the dominant deformation mechanism at rapid strain rates and at low temperatures, while dislocation channeling is favored at slower strain rates and at higher temperatures. Both mechanisms produce highly localized deformation and large surface slip steps. Channeling, in particular, is capable of creating extensive dislocation pileups and high stresses at internal grain boundaries which may promote intergranular cracking.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable