Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T15:20:33.909Z Has data issue: false hasContentIssue false

Deposition of Aluminum Nitride Films Using RF Reactive Sputtering

Published online by Cambridge University Press:  28 February 2011

N. Kumar
Affiliation:
Dept.of Electrical and Computer Engineering, Drexel University, Philadelphia, PA 19104
K. Pourrezaei
Affiliation:
Dept.of Electrical and Computer Engineering, Drexel University, Philadelphia, PA 19104
R. J. De Maria
Affiliation:
RCA, government.Systems Division, Moorestown, N.J.08057
B. Singh
Affiliation:
RCA Laboratories, Princeton, N.J.08450
Get access

Abstract

RF reactive sputtering of aluminum in argon-nitrogen mixture has been used to deposit basal oriented aluminum nitride films at temperatures lower than 200°C.X-ray diffraction studies of films deposited in 40–60% nitrogen show very high degree of crystallinity.A characteristic step-like decrease in target induced dc bias and the deposition rate (at a constant rf power level) is observed when the nitrogen content is increased above about 20%.The plot of target bias vs.nitrogen content shows a typical hysteresis loop which decreases in size at higher power levels, thus indicating nitride formation at the target surface.Glow discharge mass spectrometry was used to monitor the ions arriving at the substrate.There is a dramatic decrease in Al+ ion current when the nitrogen percentage in the gas mixture is increased above 20%.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 1986

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable