Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-15T06:00:14.414Z Has data issue: false hasContentIssue false
  • English
  • Français

Development of Novel Magnetostrictive Fe-Co-B Thin Films as a High Frequency Sensor Platform

Published online by Cambridge University Press:  06 February 2015

Zhizhi Sheng and
Z.-Y. Cheng
Zhizhi Sheng
Affiliation:
Materials Research and Education Center, Auburn University, Auburn, AL 36849, U.S.A.
Z.-Y. Cheng
Affiliation:
Materials Research and Education Center, Auburn University, Auburn, AL 36849, U.S.A.
Get access

Abstract

Fe-Co-B was identified as a potential candidate for the development of high-frequency sensors and high-frequency actuators. To fabricate high-frequency magnetostrictive resonators, Fe-Co-B magetostrictive thin films were prepared by combining electrochemical deposition and microfabrication processes. It is crucial to obtain thin films with proper microstructure and composition. Results showed that Fe-rich Fe-Co-B thin films exhibited better resonance behavior than those with Co-rich and equiatomic Fe and Co compositions. It is also found that the deposition condition plays an important role on the performance of the films. Fe55Co28B17 thin films were fabricated under the same current density for different times. The films exhibited nanocrystalline structure, circular nodules as surface morphology and good resonance behavior. Fe/Co ratio on surface and cross section slightly decreased with increasing the deposition time. The resonance frequency slightly increased and the Q value was found to decrease with increasing deposition time.

Keywords

sensorthin filmelectrodeposition

Information

Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1720: Symposium D – Materials and Concepts for Biomedical Sensing , 2014, mrsf14-1720-d10-18
Copyright
Copyright © Materials Research Society 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

Kouzoudis, D. and Mouzakis, D. E., Sensors and Actuators, A: Physical 127, 355–359 (2006).CrossRefGoogle Scholar
Zhang, K., Zhang, L., Fu, L., Li, S., Chen, H. and Cheng, Z. Y., Sensors and Actuators A: Physical 200, 2–10 (2013).CrossRefGoogle Scholar
Grimes, C., Mungle, C., Zeng, K., Jain, M., Dreschel, W., Paulose, M. and Ong, K., Sensors 2, 294–313 (2002).CrossRefGoogle Scholar
Savage, H. T. and Spano, M. L., Journal of Applied Physics 53, 8092–8097 (1982).CrossRefGoogle Scholar
Barandiarán, J. M., Gutiérrez, J. and García-Arribas, A., physica status solidi (a) 208, 2258–2264 (2011).CrossRefGoogle Scholar
Fernandez-Baca, J. A. and Ching, W.-Y., The Magnetism of Amorphous Metals and Alloys. (World Scientific Publishing Company, Incorporated, 1995).CrossRefGoogle Scholar
Graham, C. D. and Egami, T., Annual Review of Materials Science 8, 423–457 (1978).CrossRefGoogle Scholar
Grimes, C. A., Stoyanov, P. G., Kouzoudis, D. and Ong, K. G., Review of Scientific Instruments 70, 4711–4714 (1999).CrossRefGoogle Scholar