Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T04:14:47.359Z Has data issue: false hasContentIssue false

Diamond Amplified Photocathodes

Published online by Cambridge University Press:  01 February 2011

John Smedley
Affiliation:
smedley@bnl.gov, Brookhaven National Laboratory, Instrumentation, 20 Technology Street, Bldg. 535B, Upton, NY, 11973, United States, 631-344-7865
Ilan Ben-Zvi
Affiliation:
benzvi@bnl.gov, Brookhaven National Laboratory, Upton, NY, 11973, United States
Jen Bohon
Affiliation:
jbohon@bnl.gov, Case Western Reserve University, Clevand, OH, 44106, United States
Xiangyun Chang
Affiliation:
xychang@bnl.gov, Brookhaven National Laboratory, Upton, NY, 11973, United States
Ranjan Grover
Affiliation:
rgover@bnl.gov, Brookhaven National Laboratory, Upton, NY, 11973, United States
Abdel Isakovic
Affiliation:
isakovic@bnl.gov, Brookhaven National Laboratory, Upton, NY, 11973, United States
Triveni Rao
Affiliation:
triveni@bnl.gov, Brookhaven National Laboratory, Upton, NY, 11973, United States
Qiong Wu
Affiliation:
qiowu@bnl.gov, Indiana University, Bloomington, IN, 47405, United States
Get access

Abstract

High-average-current linear electron accelerators require photoinjectors capable of delivering tens to hundreds of mA average current, with peak currents of hundreds of amps. Standard photocathodes face significant challenges in meeting these requirements, and often have short operational lifetimes in an accelerator environment. We report on recent progress toward development of secondary emission amplifiers for photocathodes, which are intended to increase the achievable average current while protecting the cathode from the accelerator.

The amplifier is a thin diamond wafer which converts energetic (few keV) primary electrons into hundreds of electron-hole pairs via secondary electron emission. The electrons drift through the diamond under an external bias and are emitted into vacuum via a hydrogen-terminated surface with negative electron affinity (NEA). Secondary emission gain of over 200 has been achieved. Two methods of patterning diamond, laser ablation and reactive-ion etching (RIE), are being developed to produce the required geometry. A variety of diagnostic techniques, including FTIR, SEM and AFM, have been used to characterize the diamonds.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable