Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-19T00:16:15.569Z Has data issue: false hasContentIssue false

Dry Etching of III-V Nitrides

Published online by Cambridge University Press:  21 February 2011

S. J. Pearton
Affiliation:
University of Florida, Gainesville, FL 32611 USA
R. J. Shul
Affiliation:
Sandia National Laboratories, Albuquerque NM 87185 USA
G. F. McLane
Affiliation:
Army Research Laboratory, Ft. Monmouth NJ 07703 USA
C. Constantine
Affiliation:
Plasma Therm IP, St. Petersburg FL 33716 USA
Get access

Abstract

The chemical inertness and high bond strengths of the III-V nitrides lead to slower plasma etching rates than for more conventional III-V semiconductors under the same conditions. High ion density conditions (>3×1011cm−3) such as those obtained in ECR or magnetron reactors produce etch rates up to an order of magnitude higher than for RIE, where the ion densities are in the 109 cm−3 range. We have developed smooth anisotropic dry etches for GaN, InN, AlN and their alloys based on Cl2/CH4/H2/Ar, BCl3/Ar, Cl2/H2, C12/SF6, HBr/H2 and HI/H2 plasma chemistries achieving etch rates up to ∼4,000Å/min at moderate dc bias voltages (≤-150V). Ion-induced damage in the nitrides appears to be less apparent than in other III-V’s. One of the key remaining issues is the achievement of high selectivities for removal of one layer from another.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable