Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-17T23:01:15.498Z Has data issue: false hasContentIssue false

Effect of Processing on Oxidation of Ti5Si3

Published online by Cambridge University Press:  01 January 1992

Andrew J. Thom
Affiliation:
Ames Laboratory and Department of Materials Science and Engineering, Iowa State University, Ames, IA 50011
Youngman Kim
Affiliation:
Ames Laboratory and Department of Materials Science and Engineering, Iowa State University, Ames, IA 50011
Mufit Akinc
Affiliation:
Ames Laboratory and Department of Materials Science and Engineering, Iowa State University, Ames, IA 50011
Get access

Abstract

The mechanical properties and oxidation resistance of HIPed Ti5Si3 have been measured. HIPing submicron size powder compacts produces a crack-free, fine-grained microstructure with significantly higher hardness and toughness than a coarse-grained microstructure which contains microcracks within larger grains. Oxidation resistance is influenced by the grain size. Coarse-grained material has much lower mass gain than finegrained material in an oxidizing atmosphere and exhibits parabolic oxidation kinetics. The oxidation resistance of fine-grained material was measured between 700°C and 1000°C in air. Mass gain at 120 hours was measured to be 0.07 mg/cm2 at 700°C. At 900°C cracking of the scale leads to linear oxidation kinetics and significantly higher mass gain.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable