Hostname: page-component-7b7567c8c-2jgqx Total loading time: 0 Render date: 2026-11-19T18:12:38.512Z Has data issue: false hasContentIssue false

Effects of Bonding Process Parameters on Wafer-to-Wafer Alignment Accuracy in Benzocyclobutene (BCB) Dielectric Wafer Bonding

Published online by Cambridge University Press:  01 February 2011

F. Niklaus
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
R.J. Kumar
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
J.J. McMahon
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
J. Yu
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
T. Matthias
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
M. Wimplinger
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
P. Lindner
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
J.Q. Lu
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
T.S. Cale
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
R.J. Gutmann
Affiliation:
Center for Integrated Electronics, Rensselaer Polytechnic Institute, Troy, NY, USA.
Get access

Abstract

Wafer-level three-dimensional (3D) integration is an emerging technology to increase the performance and functionality of integrated circuits (ICs). Aligned wafer-to-wafer bonding with dielectric polymer layers (e.g., benzocyclobutene (BCB)) is a promising approach for manufacturing of 3D ICs, with minimum bonding impact on the wafer-to-wafer alignment accuracy essential. In this paper we investigate the effects of thermal and mechanical bonding parameters on the achievable post-bonding wafer-to-wafer alignment accuracy for polymer wafer bonding with 200 mm diameter wafers. Our baseline wafer bonding process with softbaked BCB (∼35% cross-linked) has been modified to use partially cured (∼ 43% crosslinked) BCB. The partially cured BCB layer does not reflow during bonding, minimizing the impact of inhomogeneities in BCB reflow under compression and/or slight shear forces at the bonding interface. As a result, the non-uniformity of the BCB layer thickness after wafer bonding is less than 0.5% of the nominal layer thickness and the wafer shift relative to each other during the wafer bonding process is less than 1 μm (average) for 200 mm diameter wafers. The critical adhesion energy of a bonded wafer pair with the partially cured BCB wafer bonding process is similar to that with soft-baked BCB.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable