Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T07:17:01.979Z Has data issue: false hasContentIssue false

The Effects of in-Situ Processing Methods on the Microstructure and Fracture Toughness of V-V3Si Composites

Published online by Cambridge University Press:  25 February 2011

M. J. Strum
Affiliation:
Lawrence Livermore National Laboratory, Livermore, CA 94550.
G. A. Henshall
Affiliation:
Lawrence Livermore National Laboratory, Livermore, CA 94550.
B. P. Bewlay
Affiliation:
GE Corporate Research and Development, Schenectady, NY 12301.
J. A. Sutliff
Affiliation:
GE Corporate Research and Development, Schenectady, NY 12301.
M. R. Jackson
Affiliation:
GE Corporate Research and Development, Schenectady, NY 12301.
Get access

Abstract

The present paper describes ductile-phase toughening in V-V3Si in-situ composites that were produced by conventional arc melting (AM), cold-crucible induction melting (IM), and coldcrucible directional solidification (DS). Notched three-point bending tests were performed to determine the effects of synthesis method on the room temperature fracture toughness of eutectic compositions, which contain nearly equal volume fractions of V3Si and the V(Si) solid solution phase. Fracture toughness values ranged from 10 MPa√m for the AM eutectic to over 20 MPa√m for the IM and DS eutectic alloys. SEM fractography, fracture surface profiling, and chemical analyses were performed to correlate the toughness values with the microstructures and interstitial concentrations produced by the three synthesis methods.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable