Hostname: page-component-7b7567c8c-8tzhz Total loading time: 0 Render date: 2026-11-19T21:25:43.623Z Has data issue: false hasContentIssue false

The Effects of Processing Variables on Reaction Synthesis of Fe-A1 Alloys

Published online by Cambridge University Press:  22 February 2011

D. L. Joslin
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831–6115
D. S. Easton
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831–6115
C. T. Liu
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831–6115
S. A. David
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831–6115
Get access

Abstract

The effects of alloy composition and reaction atmosphere on reaction synthesis of binary Fe-Al alloys were studied. Reactions were observed in an open (air) furnace, under static vacuum (in an evacuated quartz tube) and in a dynamic vacuum furnace. High-speed videotapes of reaction syntheses of compacts formed from 45-μm Fe and 10-μm Al powders reacted in air and under static vacuum revealed that an unusual “two-stage” reaction exists in this system under these conditions. The first stage of the two-stage reaction lasts several seconds and starts at around 650°C. The second stage begins at about 900°C, reaching temperatures between 1250 and 1350°C. The progress of the reaction to the second stage is sensitive to the alloy composition and reaction environment. The reaction behavior is explained in terms of thermodynamics and heat transfer, which control the delicate balance between heat accumulation and heat loss during reaction synthesis.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable