Hostname: page-component-7b7567c8c-slfcl Total loading time: 0 Render date: 2026-11-19T16:21:50.349Z Has data issue: false hasContentIssue false

Electrical Properties of Ga2O3:Sn/CIGS Hetero-junction

Published online by Cambridge University Press:  11 March 2014

Kenji Kikuchi
Affiliation:
NHK Science and Technology Research Laboratories, 1-10-11, Kinuta, Setagaya-ku, Tokyo, 157–8510, JapanGraduate School of Science and Technology, Keio University, 3-14-1, Hiyoshi, Kouhoku-ku, Yokohama, 223–8522, Japan
Shigeyuki Imura
Affiliation:
NHK Science and Technology Research Laboratories, 1-10-11, Kinuta, Setagaya-ku, Tokyo, 157–8510, Japan
Kazunori Miyakawa
Affiliation:
NHK Science and Technology Research Laboratories, 1-10-11, Kinuta, Setagaya-ku, Tokyo, 157–8510, Japan
Misao Kubota
Affiliation:
NHK Science and Technology Research Laboratories, 1-10-11, Kinuta, Setagaya-ku, Tokyo, 157–8510, Japan
Eiji Ohta
Affiliation:
Graduate School of Science and Technology, Keio University, 3-14-1, Hiyoshi, Kouhoku-ku, Yokohama, 223–8522, Japan
Get access

Abstract

There is an increased need for highly sensitive imaging devices to develop high resolution and high speed image sensors. Incident light intensity per pixel of image sensors is getting lower because the pixel resolution and frame rate of image sensors are becoming higher. We investigated the feasibility of using a photoconductor with tin-doped gallium oxide (Ga2O3:Sn)/Cu(In,Ga)Se2 (CIGS) hetero-junction for visible light image sensors. CIGS chalcopyrite thin films have great potential for improving the sensitivity of image sensors and CIGS chalcopyrite semiconductors have both a high absorption coefficient and high quantum efficiency. Moreover, the band gap can be adjusted for visible light. We applied Ga2O3 as an n-type semiconductor layer and a hole-blocking layer to CIGS thin film to reduce the dark current. The experimental results revealed that dark current was drastically reduced due to the application of Ga2O3 thin film, and an avalanche multiplication phenomenon was observed at an applied voltage of over 6 V. However, non-doped Ga2O3/CIGS hetero-junction only had sensitivity in the ultraviolet light region because their depletion region was almost completely spread throughout the Ga2O3 layer due to the low carrier density of the Ga2O3 layer. Therefore, we used Ga2O3:Sn for the n-type layer to increase carrier density. As a result, the depletion region shifted to the CIGS film and the cells had sensitivity in all visible regions. These results indicate that Ga2O3:Sn/CIGS hetero-junction are feasible for visible light photoconductors.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable