Hostname: page-component-7b7567c8c-8p88z Total loading time: 0 Render date: 2026-11-19T18:13:33.232Z Has data issue: false hasContentIssue false

Electrical Reliability of Cu and Low-K Dielectric Integration

Published online by Cambridge University Press:  10 February 2011

S. Simon Wong
Affiliation:
Center for Integrated Systems, Stanford University, CIS 202 MC 4070, Stanford, CA 94305
Alvin L. S. Loke
Affiliation:
Center for Integrated Systems, Stanford University, CIS 202 MC 4070, Stanford, CA 94305
Jeffrey T. Wetzel
Affiliation:
Advanced Products Research and Development Laboratory, Motorola, Inc., 3501 Ed Bluestein Boulevard, Austin, TX 78721
Paul H. Townsend
Affiliation:
The Dow Chemical Company, 1712 Building, Midland, MI 48674
Raymond N. Vrtis
Affiliation:
Sc humacher, 1969 Palomar Oaks Way, Carlsbad, CA 92009
Melvin P. Zussman
Affiliation:
HD MicroSystems, 334-127 Route 141 Murphy Road, Wilmington, DE 19880
Get access

Abstract

The recent demonstrations of manufacturable multilevel Cu metallization have heightened interest to integrate Cu and low-K dielectrics for future integrated circuits. For reliable integration of both materials, Cu may need to be encapsulated by barrier materials since Cu ions (Cu+) might drift through low-K dielectrics to degrade interconnect and device integrity. This paper addresses the use of electrical testing techniques to evaluate the Cu+ drift behavior of low-K polymer dielectrics. Specifically, bias-temperature stress and capacitance-voltage measurements are employed as their high sensitivities are well-suited for examining charge instabilities in dielectrics. Charge instabilities other than Cu+ drift also exist. For example, when low-K polymers come into direct contact with either a metal or Si, interface-related instabilities attributed to electron/hole injection are observed. To overcome these issues, a planar Cu/oxide/polymer/oxide/Si capacitor test structure is developed for Cu+ drift evaluation. Our study shows that Cu+ ions drift readily into poly(arylene ether) and fluorinated polyimide, but much more slowly into benzocyclobutene. A thin nitride cap layer can prevent the penetration.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable