Hostname: page-component-7b7567c8c-tnkh4 Total loading time: 0 Render date: 2026-11-17T16:15:16.135Z Has data issue: false hasContentIssue false

Excimer Laser Induced Patterning of PSZT and PLZT Flms

Published online by Cambridge University Press:  01 February 2011

Patrick William Leech
Affiliation:
Patrick.Leech@csiro.au, Molecular and Health Technologies, CSIRO, Bayview Crescent,, Clayton, 3168, Australia, +613-95452791
Anthony S Holland
Affiliation:
anthony.holland@rmit.edu.au, RMIT, School of Electrical and Computer Engineering, Melbourne, N/A, Australia
Get access

Abstract

The patterning of strontium-doped lead zirconium titanate (PSZT) and lanthanum-doped lead zirconium titanate (PLZT) films has been examined using excimer laser radiation. Both types of film were deposited by rf magnetron sputtering using in-situ heating and a controlled cooling rate in order to obtain the perovskite-oriented phase. The depth of laser ablation in both PSZT and PLZT films showed a logarithmic dependence on fluence. The threshold fluence required to initiate ablation was ∼1.25 mJ/cm2 for PLZT and ∼1.87 mJ/cm2 for PSZT films. The ablation rate of PLZT films was slightly higher than that of PSZT films over the range of fluence (10-150 J/cm2) and increased linearly with number of pulses. The higher ablation rate of PLZT films has been attributed to the finer grainsize (160-200 nm) than in the PSZT films (1.0-1.2 µm).

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable