Hostname: page-component-7b7567c8c-p67k6 Total loading time: 0 Render date: 2026-11-19T16:12:58.155Z Has data issue: false hasContentIssue false

Fabrication and Surface Morphology of YBCO Superconducting Thin films on STO Buffered Si Substrates

Published online by Cambridge University Press:  29 May 2012

Zafer Mutlu
Affiliation:
Department of Materials Science & Engineering, University of California-Riverside, Riverside, CA 92521, USA
Yasar G. Mutlu
Affiliation:
Department of Physics, Selcuk University, Selcuklu, 42079, Turkey
Mucahit Yilmaz
Affiliation:
Department of Physics, A. K. Education Faculty, Konya University, Konya, 42090, Turkey
Oguz Dogan
Affiliation:
Department of Physics, A. K. Education Faculty, Konya University, Konya, 42090, Turkey
Mihrimah Ozkan
Affiliation:
Department of Electrical Engineering, University of California-Riverside, Riverside, CA 92521, USA
Cengiz S. Ozkan
Affiliation:
Department of Materials Science & Engineering, University of California-Riverside, Riverside, CA 92521, USADepartment of Mechanical Engineering, University of California-Riverside, Riverside, CA 92521, U.S.A
Get access

Abstract

Pulsed Electron Deposition (PED) is an attractive alternative to Pulsed Laser Deposition (PLD) for growing high temperature superconductor thin films because of its relatively low cost. In this study, YBa2Cu3O7-δ(YBCO) thin film has been fabricated on silicon substrates by Pulsed Electron Deposition technique. SrTiO3 (STO) as a buffer layer has been grown between Si substrate and YBCO superconducting layer. The crystalline structures of STO/Si and YBCO/STO/Si films have been investigated by x-ray diffraction (XRD). The surface morphology and microstructure of YBCO/STO/Si thin film have been characterized with atomic force microscope (AFM) and scanning electron microscope (SEM). From the θ-2θ XRD analysis of YBCO thin films, (00l) diffraction peaks are obtained indicating they have a poor c-axis oriented structure. SEM analysis shows that the surfaces of films are crack-free, but they have some particulates. On AFM images, the droplets are clearly observed leading to a roughly surface.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable