Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T18:27:19.664Z Has data issue: false hasContentIssue false

Fabrication and Testing of Plasma-Spray Formed MoSi2 and MoSi2 Composite Tubes

Published online by Cambridge University Press:  25 February 2011

R.G. Castro
Affiliation:
Los Alamos National Laboratory, Materials Division, Los Alamos, NM 87545
J.R. Hellmann
Affiliation:
Pennsylvania State University, Center for Advanced Materials, University Park, PA 16802
A.E. Segall
Affiliation:
Pennsylvania State University, Center for Advanced Materials, University Park, PA 16802
D.L. Shelleman
Affiliation:
Pennsylvania State University, Center for Advanced Materials, University Park, PA 16802
Get access

Abstract

Plasma-spray forming has been used to fabricate thick-wall tubes of Mosi2 and Mosi2 containing concentric layers of A12O3. This process is being investigated as a potential fabrication method for producing tubular components of Mosi2 and Mosi2 composites for use in high temperature fuel-burner applications. Results will be reported on the spray forming method used to produce tubes of various sizes. The room temperature strength of pure Mosi2 tubes in the as-deposited condition, and after heat-treating at 1500 °C for 2 hours in vacuum, will also be reported. The strength of plasma sprayed Mosi2 tubes were measured via diametral compression of 0-ring and C-ring sections in air at room temperature. Qualification of the strength distribution was based on Weibull statistical theory.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable