Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T21:12:27.761Z Has data issue: false hasContentIssue false

Fabrication of Sic Matrix Composites by Liquid Phase Infiltration with a Polymeric Precursor

Published online by Cambridge University Press:  15 February 2011

Leonard V. Interrante
Affiliation:
Department of Chemistry, Rensselaer Polytechnic Institute, Troy, NY 12180-3590
C.W. Whitmarsh
Affiliation:
Starfire Systems, Inc, 877 25th Street, Watervliet, NY 12189
W. Sherwood
Affiliation:
Starfire Systems, Inc, 877 25th Street, Watervliet, NY 12189
Get access

Abstract

A process for the fabrication of SiC matrix composites has been developed which employs aliquid, highly branched, polycarbosilane (AHPCS). This polymer thermosets on heating at 200-400 °C (or at 100 °C with catalyst) and yields an amorphous SiC with low excess C and O content in 60-80% yield on pyrolysis to 1000 °C. Preforms consisting of C-coated Nicalon SiC fiber cloth, unidirectional Textron SiC SCS-6 fiber layups, or Mo boats packed with SiC whiskers, were infiltrated with the polymer, cured in an autoclave, and pyrolyzed to 1000 °C. Five to eight infiltration cycles gave net shape composites with final densities at 85-94 % of theoretical. The results of 4-point flexure tests on the as-prepared Nicalon composites indicate flexure strengths (aver. 378 MPa) that are comparable to or better than similarly reinforced CVI-SiC matrix composites. The whisker and SCS-6 composites showed a small weight loss (10-20%) on heating to 1500 °C in Ar and little or no weight change or obvious embrittlement in air at 1000 °C.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable