Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T13:18:45.624Z Has data issue: false hasContentIssue false

Faceting of Single-Crystal SrTiO3 During Wet Chemical Etching

Published online by Cambridge University Press:  15 March 2011

G. C. Spalding
Affiliation:
Department of Physics, Illinois Wesleyan University, Bloomington, IL 61702, USA
W. L. Murphy
Affiliation:
Department of Physics, Illinois Wesleyan University, Bloomington, IL 61702, USA
T. M. Davidsmeier
Affiliation:
Department of Physics, Illinois Wesleyan University, Bloomington, IL 61702, USA
J. E. Elenewski
Affiliation:
Department of Physics, Illinois Wesleyan University, Bloomington, IL 61702, USA
Get access

Abstract

We use an Atomic Force Microscope (AFM) to study changes in the surface of single-crystal SrTiO3 etched in HF-based solutions. Attention in this work has been focused upon observations of pyramidal pitting – both because of an interest in avoiding etch pits during substrate preparation prior to heteroepitaxial growth, and because of an interest in micromachining this highly polarizable material. We note that (110) SrTiO3 is surprisingly robust against the formation of pits, while pitting is significant on {100} surfaces. Particular etch rates have been measured, and we discuss anisotropies in the rates of dissolution. These data are combined to extract a macroscopic model describing processes relevant to the most extreme pitting, which we show to be associated with surface defects.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable