Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-17T13:08:41.325Z Has data issue: false hasContentIssue false

Fatigue/Creep Interactions in Ni3Al-Base Alloys

Published online by Cambridge University Press:  26 February 2011

G. M. Camus
Affiliation:
Materials Engineering Department Rensselaer Polytechnic Institute Troy, New York 12180-3590
D. J. Duquette
Affiliation:
Materials Engineering Department Rensselaer Polytechnic Institute Troy, New York 12180-3590
N. S. Stoloff
Affiliation:
Materials Engineering Department Rensselaer Polytechnic Institute Troy, New York 12180-3590
Get access

Abstract

Stress-controlled fatigue tests and fatigue crack growth rate tests respectively have been carried out on two Ni3Al Cr/Zr alloys, IC 218 at 600°C and 800°C, and IC 221 at 800°C, in vacuum, at various test frequencies. Decreasing the test frequency and/or increasing the temperature leads to a decrease in the number of cycles to failure, and a gradual disappearance of a fatigue fracture zone. In fatigue crack propagation tests, the crack growth rate only decreases at the lowest frequency and remains constant in the major part of the frequency range investigated. The fatigue propagation mode in all cases is intergranular. These trends are shown in both cases to be related to a true creep component but, under fatigue crack growth test conditions, crack blunting intervenes gradually as the frequency is decreased, leading therefore to a less severe frequency effect.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable