Hostname: page-component-7b7567c8c-wxvwp Total loading time: 0 Render date: 2026-11-16T22:42:07.242Z Has data issue: false hasContentIssue false

Finite-Element Modeling of Residual Stress in SiC Diaphragms

Published online by Cambridge University Press:  10 February 2011

Russell G. DeAnna
Affiliation:
Microfabrication Laboratory, Department of Electrical Engineering & Applied Physics, Case Western Reserve University, Cleveland, OH 44106
Christian A. Zorman
Affiliation:
Microfabrication Laboratory, Department of Electrical Engineering & Applied Physics, Case Western Reserve University, Cleveland, OH 44106
Mehran Mehregany
Affiliation:
Microfabrication Laboratory, Department of Electrical Engineering & Applied Physics, Case Western Reserve University, Cleveland, OH 44106
Get access

Abstract

Finite-element modeling of the residual stress due to expansion-coefficient mismatch between a 3C-SiC film and Si substrate is presented. The change in residual stress after bulk etching of the silicon substrate to create a suspended diaphragm is also presented. 1, 2, or 3 μm-thick 3C-SiC films are grown at 1600 K on a 100 mm diameter, 500 μm-thick, (100) Si substrate using atmospheric pressure chemical vapor deposition (APCVD) in a cold-wall, vertical-geometry, RF-induction-heated reactor. An axisymmetric, finite-element analysis (FEA) of the cooling and etching process is presented using the ANSYS54 finite-element package. The etching process is modeled by removing the Si elements in the etched region after cooling from film-growth to room temperature. The results show that residual stress in the diaphragm decreases from 3 to 8 percent after etching.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable