Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-16T21:19:02.166Z Has data issue: false hasContentIssue false

Generation of Monodisperse Protein Nanoparticles by Electrospray Drying

Published online by Cambridge University Press:  15 February 2011

A. Gomez
Affiliation:
Department of Mechanical Engineering, Yale University, P. O. Box 208286, New Haven, CT 06520-8286
D. Bingham
Affiliation:
Department of Mechanical Engineering, Yale University, P. O. Box 208286, New Haven, CT 06520-8286
L. de Juan
Affiliation:
Department of Mechanical Engineering, Yale University, P. O. Box 208286, New Haven, CT 06520-8286
K. Tang
Affiliation:
Department of Mechanical Engineering, Yale University, P. O. Box 208286, New Haven, CT 06520-8286
Get access

Abstract

The feasibility of producing relatively monodisperse and biologically active protein particles by electrospray drying is demonstrated. The process entails dissolving dry powder in an electrosprayable solution. The solution is then dispersed and, after solvent evaporation, dry residues can be collected on suitable deposition substrates. The process was demonstrated in the case of insulin. Particles were sized visually, using a scanning electron microscope (SEM), and aerodynamically, using an inertial impactor. When electrosprays of nearly saturated solutions were operated in the stable cone-jet mode, impactor data showed that the particle average aerodynamic diameter ranged from about 88 to 110 nm in diameter and the distributions were quasi-monodisperse with relative standard deviation estimated at approximately 10%. SEM observations for the same conditions showed average particle dimensions ranging from 98 to 117 nm, with predominantly doughnut shapes. Smaller particles can be generated by decreasing the insulin concentration and/or by spraying smaller liquid flow rates. The biological activity of the electrospray-processed insulin samples was confirmed by comparing binding properties on insulin receptors against a control sample. Although the maximum production rate for monodisperse insulin nanoparticles from a single cone-jet is low, at about 0.23 mg/hour, overall production can be increased by multiplexing the device with microfabrication techniques.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable