Hostname: page-component-7b7567c8c-m6dxt Total loading time: 0 Render date: 2026-11-18T12:03:34.135Z Has data issue: false hasContentIssue false

Grain Boundary Properties and Grain Growth: Al Foils, Al Films

Published online by Cambridge University Press:  15 March 2011

Katayun Barmak
Affiliation:
Department of Materials Science and Eng., Carnegie Mellon University, Pittsburgh, PA 15213
Wayne E. Archibald
Affiliation:
Department of Materials Science and Eng., Carnegie Mellon University, Pittsburgh, PA 15213
Anthony D. Rollett
Affiliation:
Department of Materials Science and Eng., Carnegie Mellon University, Pittsburgh, PA 15213
Shlomo Ta'asan
Affiliation:
Department of Mathematical Sciences, Carnegie Mellon University, Pittsburgh, PA 15213
David Kinderlehrer
Affiliation:
Department of Mathematical Sciences, Carnegie Mellon University, Pittsburgh, PA 15213
Get access

Abstract

Relative grain boundary energy as a function of misorientation angle has been measured in cube-oriented, i.e., <100> fiber-textured, 120 [.proportional]m-thick Al foil using orientation imaging microscopy and a statistical multiscale method. The energies of low-angle boundaries increase with misorientation angle, in good agreement with the Read-Shockley model. The relative energies of high-angle boundaries exhibit little variation with misorientation. Examination of the grain structure of <111> fiber-textured, 100 nm-thick Al films annealed at 400°C for 0.5-10 h shows 5 and 6 sided grains to be the most frequent, and the fraction of four-sided grains to be significant. The mean number of sides is slightly lower than the expected value of 6 for two- dimensional structures. Of lognormal, gamma and Rayleigh distributions, gamma gives the best fit to the grain size data in the films; however, the difference between gamma and lognormal is small. Grain growth is not self-similar and stagnates after one hour of annealing. The evolution of the grain size distribution with time indicates that the growth stagnation in the films is neither consistent with boundary pinning by grooving nor with conventional treatments of solute drag. Surface, elastic-strain and plastic-strain energy driving forces do not play a significant role in the grain growth and the subsequent stagnation since the films are strongly textured even in the as- deposited state. The steady-state distributions of reduced grain area for two-dimensional, Monte Carlo and partial differential equation based simulations show excellent agreement with each other, even when anisotropic boundary energies are used. However, comparison with experimental distributions reveals a significantly higher population of small grains in the experiments.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable