Hostname: page-component-7b7567c8c-9cwtv Total loading time: 0 Render date: 2026-11-19T19:14:07.918Z Has data issue: false hasContentIssue false

Growth and Structure of Metallic Barrier Layer and Interconnect Films I: Exeriments

Published online by Cambridge University Press:  10 February 2011

D. L. Windt
Affiliation:
Bell Labs, Lucent Technologies, Murray Hill, NJ 07974
J. Dalla Tortre
Affiliation:
Bell Labs, Lucent Technologies, Murray Hill, NJ 07974LPST-ESA54777-CNRS, Universite Paul Sabiatier, and LAAS-CNRS, Toulouse, France
G. H. Gilmer
Affiliation:
Bell Labs, Lucent Technologies, Murray Hill, NJ 07974
J. Sapjeta
Affiliation:
Bell Labs, Lucent Technologies, Murray Hill, NJ 07974
R. Kalyanaraman
Affiliation:
Oak Ridge National Labs, Oak Ridge, TN 3 7831
F. H. Baumann
Affiliation:
Bell Labs, Lucent Technologies, Murray Hill, NJ 07974
P. L. O'Sullivan
Affiliation:
Bell Labs, Lucent Technologies, Murray Hill, NJ 07974
D. Dunn
Affiliation:
University of Virginia, Dept. of Mat. Sci. ± Eng., Charlottesville, VA 22903
R Hull
Affiliation:
University of Virginia, Dept. of Mat. Sci. ± Eng., Charlottesville, VA 22903
Get access

Abstract

We present experimental results directed at understanding the growth and structure of metallic barrier layer and interconnect films. Numerical simulation results associated with this experimental work are presented in an accompanying paper in these proceedings. Here, thin films of Al, Ti, Cu and Ta have been grown by magnetron sputtering onto oxidized Si substrates. Using a specially-constructed substrate holder, the orientation of the substrate with respect to the growth direction was varied from horizontal to vertical. Films were grown at both low and high argon pressure; in the case of Ta, the cathode power was varied as well. The film structure and in particular the surface roughness was measured by X-ray reflectance and also by atomic force microscopy. We find that the surface roughness increases markedly with orientation angle in the case of Ta and Cu films, and in Ti films grown at high argon pressure. At low pressure, however, the Ti film surface roughness remains constant for all substrate orientations. No variation in roughness with either orientation angle or argon pressure was observed in the Al films. These results suggest that, under certain circumstances, shadowing effects and/or grain orientation (i.e., texture) competition during growth can give rise to lower density, more porous (and thus more rough) films, particularly at large orientation angles, as on sidewalls in sub-micron trenches.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable