Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T19:16:39.604Z Has data issue: false hasContentIssue false

The Growth of Submicron Eutectic Thin Film Structures

Published online by Cambridge University Press:  15 February 2011

Harvey E. Cline*
Affiliation:
General Electric Corporate Research and Development PO Box 8 Schenectady, NY 12301
Get access

Abstract

As the minimum dimension of electronic circuits is reduced below one micron, there has been increased interest in developing techniques for fabricating submicron structures. Pb-Sn, Cd-Pb and Al-Al 2Cu eutectic thin films were directionally solidified at rates between .0015 cm/sec and .15 cm/sec with both a lamp and a laser heat source to fabricate fault free submicron periodic structures. A transition from lamellar to cellular structures with increasing solidification rate was observed with a thermal gradient of 200°C/cm applied with the lamp heat source. Cells did not form with the increased thermal gradient produced by the laser heat source, 8000° C/cm. Spacings as fine as .1 micron were observed in the Cd-Pb eutectic. A maximum theoretical growth rate was estimated which corresponds to a spacing of 80A.

Information

Type
Research Article
Copyright
Copyright © Materials Research Society 1982

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable