Hostname: page-component-7b7567c8c-w7t8q Total loading time: 0 Render date: 2026-11-17T23:05:07.423Z Has data issue: false hasContentIssue false

Hall Effect Measurement System for Characterization of Doped Single Crystal Diamond

Published online by Cambridge University Press:  07 February 2013

Isil Berkun
Affiliation:
Michigan State University Electrical and Computer Engineering, East Lansing, MI, U.S.A.
Shannon N. Demlow
Affiliation:
Michigan State University Electrical and Computer Engineering, East Lansing, MI, U.S.A.
Nutthamon Suwanmonkha
Affiliation:
Michigan State University Electrical and Computer Engineering, East Lansing, MI, U.S.A.
Timothy P. Hogan
Affiliation:
Michigan State University Electrical and Computer Engineering, East Lansing, MI, U.S.A.
Timothy A. Grotjohn
Affiliation:
Michigan State University Electrical and Computer Engineering, East Lansing, MI, U.S.A.Fraunhofer USA Center for Coatings and Laser Applications, East Lansing, MI, U.S.A
Get access

Abstract

A temperature dependent Hall Effect measurement system with software based data acquisition and control was built and tested. Transport measurements are shown for boron-doped single crystal diamond (SCD) films deposited in a microwave plasma-assisted chemical vapor deposition (MPCVD) reactor. The influence of Ohmic contacts and temperature control accuracy are studied. For a temperature range of 300K-700K IV curves, Hall mobilities and carrier concentrations are presented.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable