Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T23:44:49.033Z Has data issue: false hasContentIssue false

High Quality Hot-wire Microcrystalline Silicon for Efficient Single and Multijunction N-i-p Solar Cells

Published online by Cambridge University Press:  01 February 2011

Robert L. Stolk
Affiliation:
r.l.stolk@phys.uu.nl, Utrecht University, Surfaces, Interfaces and Devices, Princetonlaan 4, Utrecht, N/A, NL-3584 CB, Netherlands, 0031 302532964, 0031 302543165
Hongbo Li
Affiliation:
H.Li@phys.uu.nl, Faculty of Science, Department of Physics and Astronomy, SID-Physics of Devices, Utrecht University, Princetonlaan 4, Utrecht, N/A, 3584 CB, Netherlands
Ronald H. Franken
Affiliation:
r.h.j.franken@phys.uu.nl, Faculty of Science, Department of Physics and Astronomy, SID-Physics of Devices, Utrecht University, Princetonlaan 4, Utrecht, N/A, 3584 CB, Netherlands
Karine H.M. Van der Werf
Affiliation:
C.h.m.vanderwerf@phys.uu.nl, Faculty of Science, Department of Physics and Astronomy, SID-Physics of Devices, Utrecht University, Princetonlaan 4, Utrecht, N/A, 3584 CB, Netherlands
Jatindra K. Rath
Affiliation:
j.k.rath@phys.uu.nl, Faculty of Science, Department of Physics and Astronomy, SID-Physics of Devices, Utrecht University, Princetonlaan 4, Utrecht, N/A, 3584 CB, Netherlands
Ruud E.I. Schropp
Affiliation:
r.e.i.schropp@phys.uu.nl, Faculty of Science, Department of Physics and Astronomy, SID-Physics of Devices, Utrecht University, Princetonlaan 4, Utrecht, N/A, 3584 CB, Netherlands
Get access

Abstract

In this paper, the potential of hot-wire chemical vapor-deposited (HWCVD) microcrystalline silicon (μc-Si) for use in solar cells is explored. Incorporation of the material in the current-limiting bottom cell of two tandem cells on plain stainless steel resulted in FF values as high as 0.77, which is much higher than the highest single junction FF. A combination of experiments, calculations and computer simulations was employed to identify causes for the observed high tandem cell FF values. Both the light intensity and the spectral composition of the bottom cell illumination in a tandem were found to contribute to an increase of the bottom cell FF. The fact that the operational voltage of a tandem cell is higher than that of the current-limiting subcell, was calculated to lead to a tandem FF that can be far higher than that of the limiting cell. Com-puter simulations with the AMPS computer code show that the current mismatch in a tandem cell reduces the recombination in the current-limiting cell, possibly by slightly enhancing the internal field of that cell. Use of a 1.5 μm ìc-Si:H hot-wire deposited absorber layer in a single junction cell on a textured back reflector yielded a Voc, FF and Jsc of 0.543 V, 0.656 and 23.60 mA/cm2, respectively, which combine to an 8.4 % record efficiency for μc-Si single junction n-i-p cells with a hot-wire intrinsic layer.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable