Hostname: page-component-7b7567c8c-2n9c9 Total loading time: 0 Render date: 2026-11-17T11:37:54.112Z Has data issue: false hasContentIssue false

High Temperature Stable WSi2-Contacts on p-6H-Silicon Carbide

Published online by Cambridge University Press:  10 February 2011

Frank Erler
Affiliation:
Technical University of Ilmenau, Institute of Applied Materials Science, Germany
Henry Romanus
Affiliation:
Technical University of Ilmenau, Institute of Applied Materials Science, Germany
Jörg K. N. Lindner
Affiliation:
University of Augsburg, Institute of Physics, Germany
Lothar Spiess
Affiliation:
Technical University of Ilmenau, Institute of Applied Materials Science, Germany
Get access

Abstract

Amorphous tungsten-silicon layers were deposited by DC co-sputtering and subsequently annealed in an argon atmosphere up to 1325 K to form tetragonal crystalline WSi2. Al-implanted p-6H-SiC exhibits a small depletion area forming an ohmic contact with low specific contact resistance. A modified Circular Transmission Line Model (CTLM), introduced by Marlow & Das [1] and Reeves [2], was used to characterize the electrical properties of the prepared contacts in the range between 300 K and 650 K. Deviations between calculated fieldemission contact resistances and measured contact resistances (ρc=2·10−2 Ωcm2, T=650 K) could be explained by TEM-cross section investigations. These deviations are caused by inhomogeneous contact interfaces originating from technological difficulties during contact preparation.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable