Hostname: page-component-7b7567c8c-fvjsw Total loading time: 0 Render date: 2026-11-16T12:27:12.708Z Has data issue: false hasContentIssue false

Hydrogen-plasma etching of thin amorphous silicon layers for heterojunction interdigitated back-contact solar cells

Published online by Cambridge University Press:  10 May 2013

Stefano. N. Granata
Affiliation:
IMEC, Kapledreef 75, B-3001 Heverlee, BelgiumKU Leuven ESAT Kasteelpark Arenberg 10 B-3001 Heverlee Belgium
Twan Bearda
Affiliation:
IMEC, Kapledreef 75, B-3001 Heverlee, Belgium
Ivan Gordon
Affiliation:
IMEC, Kapledreef 75, B-3001 Heverlee, Belgium
Jef Poortmans
Affiliation:
IMEC, Kapledreef 75, B-3001 Heverlee, BelgiumKU Leuven ESAT Kasteelpark Arenberg 10 B-3001 Heverlee Belgium
Robert Mertens
Affiliation:
IMEC, Kapledreef 75, B-3001 Heverlee, BelgiumKU Leuven ESAT Kasteelpark Arenberg 10 B-3001 Heverlee Belgium
Get access

Abstract

In this study, A H2-plasma is studied as a dry method to etch thin layers of amorphous silicon aSi:H(i) deposited on a crystalline wafer. It is found that H2-plasma etches aSi:H(i) selectively toward silicon nitrides hard masks with an etch rate below 3nm/min. Depending on power density and temperature of the substrate during the H2-plasma, the energy bandgap, the hydrides distribution and the void concentration of the aSi:H(i) layers are modified and the amorphous-to-crystalline transition is approached. At high temperature (>250C) and low plasma power (<20mW/cm2), the dihydride (SiH2) content increases and the bandgap widens. The etch rates stays below 0.5 nm/min. At low temperature (<150°C) and high power (>70mW/cm2), the void concentration increases significantly and etch rates up to 3nm/min are recorded.

These findings are supported by a theoretical model that indicates formation of Si-H-Si precursors in the layer during exposure to H2-plasma. According to the experimental conditions, these precursors either diffuses and forms Si-Si strong bonds or are removed from the film, causing layer etching.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable