Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-17T23:51:25.899Z Has data issue: false hasContentIssue false

Indentation Creep of Molybdenum: Comparison Between Thin Film and Bulk Material

Published online by Cambridge University Press:  21 February 2011

K. B. Yoder
Affiliation:
Department of Materials Science and Engineering, University of Wisconsin-Madison
D. S. Stone
Affiliation:
Department of Materials Science and Engineering, University of Wisconsin-Madison
J. C. Lin
Affiliation:
Surface Technology Division, ALCOA Research Center, Alcoa Park, PA.
R. A. Hoffmann
Affiliation:
Surface Technology Division, ALCOA Research Center, Alcoa Park, PA.
Get access

Abstract

Indentation creep, load relaxation, and rate-change experiments probe room temperature and 80°C creep properties of a 1.3 μm-thick molybdenum film on silicon. The film, with 0.51 GPa compressive stress, 8 GPa hardness and estimated 40 nm grain size, was deposited using steered-arc evaporation at -17V bias. Despite its small grain size and high hardness, the thin film behaves like bulk molybdenum does: the rate sensitivity of the hardness is only weakly-dependent on measurement path (as with bulk material), and activation volumes calculated based on strain rate sensitivity are consistent with those of bulk molybdenum We suspect deformation mechanisms are similar to those in bulk molybdenum under similar conditions.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable