Hostname: page-component-7b7567c8c-7pwfn Total loading time: 0 Render date: 2026-11-16T19:50:29.305Z Has data issue: false hasContentIssue false

Indium Tin Oxide Thin Films Deposited at Low Temperature Using Dual Ion Beam Sputtering

Published online by Cambridge University Press:  03 June 2014

Wilhelmus J. Geerts
Affiliation:
Department of Physics, Texas State University, San Marcos, TX 78666, USA
Nelson A. Simpson
Affiliation:
Department of Physics, Texas State University, San Marcos, TX 78666, USA
Alan D. Woodall
Affiliation:
Department of Physics, Texas State University, San Marcos, TX 78666, USA
Maclyn Stuart Compton
Affiliation:
Department of Physics, Texas State University, San Marcos, TX 78666, USA
Get access

Abstract

ITO samples were sputtered at room temperature by ion assisted dual ion beam sputtering using atomic or molecular oxygen. The electrical properties appear to depend on the oxygen flow rate during deposition and the resistivity decreases for samples sputtered at a higher oxygen flow rate (1-5 sccm). The resistivity is lowest at an oxygen flow rate of 4 sccm. The average absorption in the visible part of the spectrum also decreases as a function of the oxygen flow rate and is lower for samples sputtered with atomic oxygen. The figure of merit, i.e. the ratio of the conductivity versus the average absorption in the visible range, increases for higher oxygen flow rates and is typically 20-60% higher for samples sputtered using an atomic oxygen assist beam.

Information

Type
Articles
Copyright
Copyright © Materials Research Society 2014 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable