Hostname: page-component-7b7567c8c-z4zkx Total loading time: 0 Render date: 2026-11-16T07:39:13.708Z Has data issue: false hasContentIssue false

The Influence of Strain Rate on Dislocation Structures in γ/α2 Titanium Aluminides Deformed at 815°C

Published online by Cambridge University Press:  26 February 2011

W.T. Donlon
Affiliation:
Ford Motor Company, Research Staff, Dearborn, MI 48121–2053
W.E. Dowling Jr.
Affiliation:
Ford Motor Company, Research Staff, Dearborn, MI 48121–2053
J.E. Allison
Affiliation:
Ford Motor Company, Research Staff, Dearborn, MI 48121–2053
Get access

Abstract

Elevated temperature (815°C) compression tests were performed at strain rates between 10−2 & 10−5 sec−1 on a γ/α2 alloy, Ti-48Al-1V-0.2C (at%), for two different α2 volume fractions. A large change in the flow stress was observed to occur for strain rates between 1.10−5 & 1.10−3 sec−1. The dislocations observed in the primary γ grains deformed at the high strain rates were “regular” 1/2<110]; screw dislocations. The dislocations observed at slow strain rates were also regular 1/2<110] dislocations, however their orientation was changed so that they were aligned close to [001]. Dislocation structures produced during high cycle fatigue are identical to those observed during high strain rate compression tests, while dislocation structures produced during tensile (ė- 8.10−4 sec−1 ) tests are identical to those observed in the slow strain rate compression tests. Analysis of the orientation of deformed primary γ-TiAl grains shows that the CRSS for {111}<101] slip must be at least 1.4 times the CRSS of {111}1/2<110] slip.

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable